Setting and servicing the SW510
The figures a watchmaker or a timegrapher needs for the SW510, as Sellita prints them.
All SW510 figures
Every figure we hold for the SW510, with its source. Where sources disagree, each value is shown.
SW510 questions
What is the lift angle of the SW510?
50°, as Sellita prints it. Enter 50° on a timegrapher to read amplitude correctly for the SW510.
Source [1]
How accurate is the SW510?
Sellita rates the SW510 at ±5 s/day, measured under Sellita’s own test conditions; a worn SW510 can run outside the ±5 s/day range.
Source [1]
How long does the SW510 run when fully wound?
About 62 h from a full wind, per Sellita; a full hand wind takes about 41 crown turns.
Source [1]
Does the SW510 hack and hand-wind?
Yes, it hacks: the seconds hand stops with the crown pulled out. It can be wound by the crown.
Source [1]
What dial, hands and case fit the SW510?
Sellita lists casing diameter 30 mm; stem part number 051.010.00015. A dial, a set of hands or a case fits the SW510 when it matches these figures.
Source [1]
More on movements
- Sellita movementsEvery Sellita calibre with its key figures
- Movement comparisonPut the SW510 next to up to three other calibres
- Quartz vs automatic watchWhere the SW510 sits: accuracy, power and upkeep, in numbers
- Watch movement types explainedAutomatic, hand-wound, quartz, solar and digital modules side by side
- Watch accuracy calculatorCheck an SW510 against Sellita's figures
- All movementsCatalogue by maker and type
Sources
Documents checked · Report a wrong number
- 1SELLITA WATCH Co S.A. — Documentation technique SW510 (DocTec) · pdf · read